Maytag and Amana diagnostic technicians
Available in Killeen TX
Top-load, front-load, gas and electric dryer
Before any work starts
Fort Cavazos and Bell County families
Stuck on sensing, water left in drum, or damp clothes after heat all point to different paths.
No repair starts until you approve the price.
Washer stuck on sensing: lid lock, actuator, control, or water-level issue.
Washer not spinning: belt, hub, shift actuator, motor, or lid-lock fault.
Washer not draining: pump clog, drain hose blockage, or pump motor failure.
Grinding noise: splutch, hub, bearing, or drive component wear.
Lid locked and will not open: latch, control, or interrupted cycle fault.
Front-load washer leaking: door boot, drain path, or dispenser issue.
Dryer not heating: thermal fuse, heating element, gas valve coil, or thermostat fault.
Dryer runs but clothes stay damp: sensor bars, airflow restriction, or cycling thermostat issue.
Squealing or thumping: rollers, idler pulley, belt, or bearing wear.
Gas dryer ignites then shuts down: gas coil or flame sensor pathway.
Dryer shuts off mid-cycle: overheating, thermostat, motor, or control issue.
Display or control panel not responding: board, touchpad, or power issue.
Refrigerator not cooling: start device, evaporator fan, thermistor, or control fault.
Ice maker producing hollow or small cubes: fill tube, water valve, or temperature issue.
Dishwasher not draining: pump, check valve, drain line, or control fault.
Dishwasher not cleaning: wash motor, spray path, or inlet issue.
Oven not heating evenly: bake element, igniter, sensor, or control relay issue.
Range burner not lighting: igniter, switch, spark module, or element issue.
Tells us whether the machine is older mechanical Maytag, Whirlpool-built Maytag, Amana-family, Pet Pro, or another platform.
Helps confirm age, warranty possibility, and part compatibility.
Stuck on sensing after filling is more useful than only saying it will not spin.
Codes such as F8, F9, F5, LF, Sd, OL, or lid-lock messages point toward the correct system.
Gas and electric dryers use different heating systems. Tell us which one you have.
Power outage, moving the appliance, overload, pet bedding load, water shutoff, or drain backup can change the likely cause.
Confirmed by phone
Age and model matter
Included on this page
Honest repair math
Approve before work starts
Ask when calling